BYWVY - ECO-PRIME, 24-99
- MSDS: BYWVY
- Manufacturer: PRESERVATIVE PAINT CO
- Product Name: ECO-PRIME, 24-99
- National Stock Number: 8010-00N063371
Product Identification
Product ID:ECO-PRIME, 24-99
MSDS Date:03/03/1993
FSC:8010
NIIN:00N063371
MSDS Number: BYWVY
Responsible Party
SEATTLE, WA 98108
US
Emergency Phone: 800-424-9300 (CHEMTREC)
Info Phone: 206-763-0300
Cage: 86589
Contractor
Cage: 86589
Ingredients
TITANIUM OXIDE; (TITANIUM DIOXIDE)
CAS: 13463-67-7
RTECS: XR2275000
Fraction By Weight: 10-15%
OSHA PEL 15 MG/M3 TDUST
ACGIH TLV: 10 MG/M3 TDUST
TALC (POWDER), CONTAINING NO ASBESTOS FIBERS; (MAGNESIUM
CAS: 14807-96-6
RTECS: WW2710000
Fraction By Weight: 20%
OSHA PEL 20 MPPCF Z-3
ACGIH TLV: 2 MG/M3 RDUST
PROPIONIC ACID, 3-ETHOXY-, ETHYL ESTER;
CAS: 763-69-9
RTECS: UF3325000
Fraction By Weight: 3%
OSHA PEL N/K
ACGIH TLV: N/K
0.6 @ 68F
CAS: 5131-66-8
RTECS: UA7700000
Fraction By Weight: 2%
OSHA PEL N/K
ACGIH TLV: N/K
1.10 LB/GL (131 G/L) (COATING);
RTECS: 9999999VO
OSHA PEL N/K
ACGIH TLV: N/K
Hazards
LD50 LC50 Mixture:NONE SPECIFIED BY MANUFACTURER.
Routes of Entry: Inhalation:YES Skin:YES Ingestion:YES
Reports of Carcinogenicity:NTP:NO IARC:NO OSHA:NO
Health Hazards Acute and Chronic:ACUTE: INHAL: NOT NORM A HAZ UNLESS
SPRAYED. OVERSPRAY & SPRAY MISTS ARE PRIMARILY CONSIDERED NUISANCE
DUSTS. SKIN CONT: RPTD/PRLNG LIQ CONT MAY CAUSE SKIN IRRIT
W/DISCOMFORT & DERM. EYES: MAY CAUSE I RRIT/BURNING. INGEST: MAY
CAUSE GI DISTRESS. CHRONIC: OVEREXP TO ETHYLENE GLYCOL MAY CAUSE
CNS (EFTS OF OVEREXP)
Explanation of Carcinogenicity:NOT RELEVANT.
Effects of Overexposure:HLTH HAZ: DEPRESS, CARDIOPULM FAILURE, LIVER &
KIDNEY DMG & BIRTH DEFECTS. REPORTS HAVE ASSOC RPTD/PRLNG OVEREXP
TO SOLV W/PERM BRAIN & CNS DMG. UNDER NORM CNSUMER USE CNDTNS,
LIKELIHOOD OF ANY ADVERS E HLTH EFTS ARE LOW.
Medical Cond Aggravated by Exposure:NO MEDICAL CONDITIONS ARE KNOWN TO
BE AGGRAVATED BY EXPOSURE TO THIS PRODUCT.
First Aid
First Aid:EYES: FLUSH WITH WATER FOR AT LEAST 15 MINUTES. CALL MD.
SKIN: REMOVE CONTAMINATED CLOTHING AND WASH EXPOSED AREA WITH SOAP
AND WATER. INHALATION: REMOVE TO FRESH AIR. IF NOT BREATHING, GIVE
ARTIFICIA L RESPIRATION, PREFERABLY MOUTH-TO-MOUTH. IF BREATHING
DIFFICULTY PERSISTS OR OCCURS LATER, CONSULT MD. INGEST: CALL MD
IMMEDIATELY. DO NOT INDUCE VOMITING.
Fire Fighting
Lower Limits:1.0%
Extinguishing Media:USE FOAM, ALCOHOL FOAM, CARBON DIOXIDE, DRY
CHEMICAL, WATER FOG, OTHER.
Fire Fighting Procedures:WEAR NIOSH/MSHA APPROVED SCBA & FULL
PROTECTIVE EQUIPMENT . COOL CLOSED CONTAINERS WITH WATER FOG TO
PREVENT PRESSURE BUILD-UP.
Unusual Fire/Explosion Hazard:CLOSED CONTAINERS MAY EXPLODE DUE TO A
BUILD-UP OF STEAM PRESSURE WHEN EXPOSED TO EXTREME HEAT.
Accidental Release
Spill Release Procedures:VENTILATE AREA. PREVENT SKIN CONTACT AND
BREATHING OF VAPORS. CONFINE AND REMOVE WITH INERT ABSORBENT
MATERIALS.
Neutralizing Agent:NONE SPECIFIED BY MANUFACTURER.
Handling
Handling and Storage Precautions:OBSERVE LABEL PREC. KEEP CLOSURES
TIGHT WHEN NOT IN USE. STORE IN UPRIGHT POSITION TO PVNT LEAKAGE.
DO NOT EXCEED STOR BETWEEN 40F AND 120F.
Other Precautions:KEEP AND STORE OUT OF REACH OF CHILDREN. DO NOT SAND,
FLAME CUT, BRAZE OR WELD DRY COATING WITHOUT WEARING A NIOSH/MSHA
APPROVED RESPIRATOR OR APPROPRIATE VENTILATION.
Exposure Controls
Respiratory Protection:FOR BRUSH AND ROLLER APPLICATIONS, RESPIRATORY
PROTECTION IS NOT NORMALLY REQUIRED. FOR SPRAY APPLICATION, A
PROPERLY FITTED VAPOR/PARTICULATE NOSH/MSHA APPROVED RESPIRATOR IS
RECOMMENDED.
Ventilation:SUFFICIENT IN PATTERN AND VOLUME TO KEEP VAPORS BELOW
APPLICABLE OSHA REQUIREMENTS.
Protective Gloves:SOLVENT IMPERVIOUS GLOVES.
Eye Protection:ANSI APPRVD CHEM WORKERS GOGGS .
Other Protective Equipment:ANSI APPRVD EMER EYEWASH & DELUGE SHOWER .
COVERALLS REC. SOLVENT IMPERVIOUS APRON REC IF BODY CONT MAY OCCUR.
Work Hygienic Practices:WASH THORO AFTER HNDLG, BEFORE EATING/SMKNG.
WASH CONTAM CLTHG BEFORE REUSE. PERIODIC MONITORING OF EXPOS
LEVEL/LIM REC.
Supplemental Safety and Health
NONE SPECIFIED BY MANUFACTURER.
Chemical Properties
Boiling Pt:B.P. Text:212F,100C
Vapor Pres:SEE INGS
Vapor Density:HVR/AIR
Spec Gravity:1.3 (H*2O=1)
Evaporation Rate & Reference:SLOWER THAN ETHER
Solubility in Water:MODERATE
Appearance and Odor:MILKY WHITE TO VARIOUS COLORS, WITH A FAINT AMMONIA
ODOR
Stability
Stability Indicator/Materials to Avoid:YES
NONE REASONABLY FORESEEABLE.
Stability Condition to Avoid:NONE REASONABLY FORESEEABLE.
Hazardous Decomposition Products:OXIDES OF CARBON.
Disposal
Waste Disposal Methods:DO NOT ALLOW MATERIAL TO CONTAMINATE GROUND
WATER SYSTEMS. ABSORB LARGE SPILLS WITH INERT ABSORBENT MATERIAL.
DISPOSE OF ABSORBED MATERIAL IN ACCORDANCE W/LOCAL, STATE & FEDERAL
REGULATORY REQUIREMENT S. DO NOT INCINERATE IN CLOSED CONTAINERS.
Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.